LINUX LITE 7.4 FINAL RELEASED - SEE RELEASE ANNOUNCEMENTS SECTION FOR DETAILS


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Automatically mount partitions in Linux Lite
#1
Hi there!
I've already seen this question posted, but couldn't find a solution to work for me. Please keep in mind that I'm new with Linux and don't know much about it. Smile
So, I installed Linux Lite, I already set up the partitions, but I can't figure how to mount them.
My fdisk -l results are as follows:

Disk /dev/sda: 465,8 GiB, 500107862016 bytes, 976773168 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disklabel type: dos
Disk identifier: 0x53e74323

Device    Boot    Start      End  Sectors  Size Id Type
/dev/sda1  *        2048 146485247 146483200  69,9G 83 Linux
/dev/sda2      146487294 976771071 830283778 395,9G  5 Extended
/dev/sda5      146487296 732422143 585934848 279,4G 83 Linux
/dev/sda6      732424192 771483647  39059456  18,6G 82 Linux swap / Solaris
/dev/sda7      771485696 976771071 205285376  97,9G 83 Linux

Partition 2 does not start on physical sector boundary.

Any ideas? Thanks in advance.

Reply


Messages In This Thread
Automatically mount partitions in Linux Lite - by Calin Musceleanu - 12-15-2019, 12:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)